I just got a Toodles Imp v2 to put in my Hori FSV3 I plan on mounting it ontop of the existing PCB (after shorting the proper jumpers) and wiring it according to the directions at http://godlikecontrols.com/imp2.pdf
I have a few questions:
There are two Black USB wires. Which do I use to wire to 'G'?
Can I use any 360 wired PCB I want to wire into the Toodles? Are there any specific ones that work best or some that I should avoid?
What's a good way to attach the toodles securely onto the stock PCB?
Here's a diagram I MSpainted with the toodles ontop of the stock PCB. Does this look good?
![mamX4o7.jpg]()
I have a few questions:
There are two Black USB wires. Which do I use to wire to 'G'?
Can I use any 360 wired PCB I want to wire into the Toodles? Are there any specific ones that work best or some that I should avoid?
What's a good way to attach the toodles securely onto the stock PCB?
Here's a diagram I MSpainted with the toodles ontop of the stock PCB. Does this look good?
